All Categories
EN

News

Home>News

2019/02 Your Quick Guide to the New ANSI/ISEA 138 Impact Standard

Time : 2019-02-01 Hits : 24

The wait is over – the new ANSI/ISEA 138 Impact Standard has officially been published! It’s no secret that hand injuries are some of the most common among jobsites, but they are also some of the most preventable – and thanks to this new impact protection standard, hand injuries will be more preventable than ever. Here’s what you need to know about ANSI/ISEA 138.

 

Raising the Standard

Until now, the ANSI/ISEA 105:2016 hand protection standard covered cut, abrasion, tear, and puncture performance ratings, but there was no U.S.-based standard to help measure impact performance. This gave glove manufacturers free reign on glove claims when it came to the protective nature of their impact technology, which made it very difficult for safety managers to choose proper impact protection. It also created confusion in the market as to what was protective enough for certain applications, and what was not.

 

What Will the New Impact Standard Do?

Published February 27, 2019, the new ISEA 138 standard establishes the minimum performance, classification and labeling requirements for gloves that are designed to protect the knuckles and fingers from impacts. This will help safety professionals make better-informed decisions about glove selection – ultimately keeping more people safe on the job.

 

How Does the Impact Test Work?

One pair of gloves is required per test. The gloves are cut in half and the back-of-hand is placed on an anvil. A striker with a force of 5 Joules is dropped on the required back-of-hand locations. The amount of force transferred through the glove back-of-hand is recorded with a force gauge that is connected below the anvil.

 

The ISEA 138 will test two areas for impact performance: knuckles, and fingers/thumb. On both gloves, knuckles are tested four times and fingers/ thumb are tested five times. The average of the knuckle tests is compared to the average of the ten finger tests. The highest average of the two (the highest amount of force transferred which delivers a lower score) is the final impact testing score. The chart with glove markings below showcases the performance levels, with “Performance Level 3” being the highest.

ISEA 138 gives more choice and flexibility to the end-user. With a performance level scale, workers can make better informed decisions as to what type of glove will give them the appropriate level of impact protection based on the hazards they may face.

 

ISEA 138 Requires Lab Testing

The ANSI/ISEA 138 standard is unlike most standards from ANSI, where PPE manufacturers are on an honor system when it comes to publishing test results. ISEA 138 requires testing in a lab that meets the laboratory conformity assessment standard IOS/IEC 17205. This helps increase the credibility of glove performance level claims and is a progressive step for ANSI/ISEA.

 

All performance levels will be displayed directly on the gloves to give safety professionals a simple visual of what the performance standard is.